Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 10 (kliknij aby zobaczyć)
To assemble and connect the AM loop antenna
To assemble the AM loop antenna
Changing the Scanning Mode
Remote ONLY
This System supports progressive scanning. If you connect a progressive TV through the COMPONENT jacks, you can enjoy a high quality picture from the built-in DVD player by selecting progressive mode.
PROGRE INTER
(at the same time) 3 Release
To connect the AM loop antenna
1 Hold 2 Insert
PROGRE (Progressive) INTER (Interlaced)
Progressive scanning. For a progressive TV. The PROGRESSIVE indicator lights. Interlaced scanning. For a conventional TV.
� If the AM loop antenna wire or speaker cords are covered with vinyl, remove the vinyl to expose the tip of the antenna by twisting the vinyl. � Make sure the antenna conductors do not touch any other terminals, connecting cords and power cord. Also, keep the antennas away from metallic parts of the System, connecting cords, and the AC power cord. This could cause poor reception.
To connect the speaker cords
Connect the right speaker to the R terminals, and the left speaker to the L terminals.
1 Hold 2 Insert 3 Release
When connecting the speaker cords, match the polarity of the speaker terminals: gray cord (+) to red (+) and gray cord with black stripe (�) to black (�). � DO NOT connect more than one speaker to each terminal. � DO NOT allow the conductor of the speaker cords to be in touch with the metallic parts of the System.
