Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 7 (kliknij aby zobaczyć)
2 STEP 5
IMPORTANT: To prevent siphoning, do not place Push rubber into Position and level washer ribbed portion of drain hose into standpipe. Avoid
end of fill hose air-tight seal around standpipe adapter.
Position washer on clean, dry, firm, and level floor. Place rubber foot pads on all four leveling legs. NOTE: To avoid damage to legs and base, do T
5 POSITION AND LEVEL WASHER
bubble level
D
7
H not slide washer across floor if leveling legs haveO
O been Cextended.
L
Loosen /8" locknuts and adjust front 2 leveling legs until machine is level front-to-back and side-to-side. Be sure machine does not rock. Tighten locknuts up to washer base,
Connect or washer will move out of position during operation. water fill hoses front legs and lower into place to correctly set rear selfto washer leveling legs. WASHER MUST NOT ROCK.
Once front legs are adjusted, gently tilt washer forward on
6
locknut leveling leg rubber foot pad BEFORE FIRST USE TO WASH CLOTHES, Run through one wash cycle. STEP 6 Connect water fill hoses
HOT
COLD
7 To prevent damage to pump, add at least 1 quart of water Connect power cord to water from first use stays in drain system to cool pump and prevent seal damage. faucet
CONNECT POWER CORD TO ELECTRICITY See Electrical Requirements on page 4. Plug washer into 3-prong grounded outlet.
STEP 3 7 add water and detergent to washtub.
to tub before first use. Pump seal may overheat and leak if
to faucets electricity washer used before water is added. Small amount of
screen filter Questions? STEP 7
hose clothes, add water and
Before first use to wash See Washing Guide or call Amana
