To Remove the Dispenser for Cleaning
1) Support the bottom of the dispenser with one hand. Use a quarter and turn four slotted screws counter clockwise 1/4 turn (figure 4). 2) Pull the dispenser out from the bottom of the lid. 3) Remove fill cap. 4) Fill with water about half way. Move the dispenser from side to side to wash out detergent. 5) With the dispenser over a large sink or bath tub, turn it upside down to empty the water/detergent out of the dispenser fill area. Figure 4
To Replace the Dispenser
l ) Place the top of tbe dispenser in the top lip of the lid. 2) Push the bottom of the dispenser into the bottom of the lid. 3) While supporting the bottom, use a quarter and turn each of the four screws 1/4 turn clockwise to lock the dispenser into place. 4) Close the washer lid. 5) Open the washer lid. 6) Press the "PUSH" button to release any remaining water/detergent. Repeat steps 4-6 until no more water can be drained from the dispenser. It is normal for a small amount of water to remain in the dispenser after cleaning. 7) Refill the dispenser (see page 6). with your favorite detergent
