Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 20 (kliknij aby zobaczyć)
Troubleshooting
WARNING Do not open the system as there is a risk of electric shock! Under no circumstances should you try to repair the system yourself, as this will invalidate the warranty ¶ If a fault occurs, first check the points listed below before taking the system for repair. ¶ If you are unable to remedy a problem by following these hints, consult your dealer or service center.
E n g l i s h
20
Symptom
CD PLAYER OPERATION �NO DISC� is displayed.
Remedy
¶ Check if the disc is inserted upside down. ¶ Wait until the moisture condensation at the lens has cleared. ¶ Use a finalized CD-R(W). ¶ Replace or clean the disc, see Maintenance. ¶ The signal is too weak, adjust the antenna or connect an external antenna for better reception. ¶ Increase the distance from TV or VCR. ¶ Clean deck parts, see Maintenance. ¶ Use only NORMAL (IEC I) tape for recording. ¶ Apply a piece of adhesive tape over the missing tab space. ¶ Reconnect the AC power plug and switch on the system again. ¶ Press STANDBY ON to switch off the system. Remove the AC power plug from the wall outlet, then reconnect the power plug and switch on the system again. ¶ Adjust the volume. ¶ Disconnect the headphones. ¶ Check that the speakers are connected correctly. ¶ Check if the stripped speaker wire is clamped. ¶ Check the speaker connections and location. ¶ Select the source (CD, TUNER, etc.) before pressing the function button (Ã�,Ã,ë, etc.). ¶ Reduce the distance to the system. ¶ Insert the batteries with their polarities (+/- signs) as indicated. ¶ Replace the batteries. ¶ Set the clock. ¶ Press TIMER ONâ�¢OFF to switch on the timer. ¶ If recording is in progress, stop recording.
RADIO RECEPTION Poor radio reception.
TAPE DECK OPERATION Recording or playback cannot be made. �CHECK TAPE� is displayed. Tape deck door cannot open. GENERAL Does not react when any buttons is pressed.
No or poor sound.
Reversed left and right sound. Remote control does not function properly.
