...instrukcja serwisowa w pełni czytelna i kompletna. Dziękuję!
Tekstowy podgląd strony 15 (kliknij aby zobaczyć)
REPLACEMENT OF MAIN PARTS
3. Separate cord reel unit and cord reel support. (Fig. 18) 4. Replace the cord reel unit with a new one. 5. Reassemble cord reel unit and cord reel support and refasten the screw. NOTE: Wind up the power cord extra times as indicated on the spring plate to maintain the cord reel spring efficiency. 6. Connect the lead wires according to the schematic diagram and place the cord reel ass�y into place. Then reassemble the remaining parts in the reverse order.
Cord reel unit Cord reel support
Screw
Fig. 18 (2) Power cord 1. Remove cord reel unit and dissamsenble it as explained previously in paragraph (1) �Cord reel unit�, points 1-3. 2. Unwind the total power cord length from the cord reel. 3. Press and release the stopper on the cord reel and lift the contact base by pushing the lower end. (Fig. 19) 4. Disconnect the power cord from the contact base and replace it with a new one. (Fig. 20) NOTE: Observe the colour of the power cord lead wires before reinstalling the new one. 5. Insert the contact base through the cord reel slot and wind up the total power cord length in the arrow direction as indicated on the spring plate. (Fig. 21) 6. Reassemble cord reel unit and cord reel support and refasten the screw. Then wind up the power cord extra times as indicated on the spring plate to maintain spring efficiency. 7. Place cord reel ass�y into the lower body . Connect the lead wires according to he schematic diagram and reassemble the remaining parts in the reverse order.
Blue wire Stopper
