Bardzo dobra jakość skanu, przystępna cena. Instrukcja serwisowa okazała się przydatna przy "reanimowaniu" dwudziestoparoletniego decka, który teraz pięknie gra :)
Documentation made available quickly and It is good quality. Thanks.
Tekstowy podgląd strony 10 (kliknij aby zobaczyć)
MC-UG383-00
and the plastic shaft. Pry out the plastic shaft as illustrated.
4. Carefully lift up on the agitator assembly until it clear both sides of the nozzle housing.
3.4.2.
Installation
5. Remove the nozzle housing as illustrated. 6. Remove the nozzle packing, window and handle release assembly.
1. Place the belt around the motor shaft. 2. Place the belt around the agitator pulley on the agitator assembly. NOTE: There is a place for the belt to fit on one end of the agitator assembly only. This is the agitator pulley. 3. Reassemble the new agitator assembly back into the nozzle housing by placing the side opposite the belt partially into the slot. The small tabs should be aligned against the nozzle and the other against the lower plate. This will hold the agitator in place and leave both hands free to place enough tension on the belt to allow that side of the agitator to return to the nozzle housing slot. 4. Use both hands to pull the belt tight, and slide the agitator assembly firmly into the slots on each end of the nozzle housing. 5. Rotate the agitator assembly by hand to insure nothing rubs and check for correct assembly. 6. Replace the lower plate as outlined in the LOWER PLATE REMOVAL/INSTALLATION section.
3.5.2.
Installation
1. Install the nozzle packing, if not already in place, window and handle release assembly in the new nozzle housing. 2. Fit the nozzle around the motor shaft side first, and rotate it into place on the dust container as illustrated.
3.5.
3.5.1.
Nozzle Housing Replacement
Removal
3. Slide the plastic shaft through the nozzle housing and into the dust container. Make sure that the slot on the bottom of the plastic shaft is down and seated onto the projection.
1. Remove the lower plate as outlined in the LOWER PLATE REMOVAL/INSTALLATION section. 2. Remove the belt and agitator assembly as outlined in the respective sections. 3. Remove the nozzle hose by pulling up on the hose to remove it from the nozzle housing. Pull the nozzle hose out of the back of the nozzle housing.
4. Insert a flat blade screwdriver between the nozzle housing 10
4. Reassemble the nozzle hose by inserting it into the nozzle
