jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
Instrukcja bardzo czytelna. zawiera co potrzeba. Polecam
Tekstowy podgląd strony 4 (kliknij aby zobaczyć)
EXPLODED VIEW (POWER NOZZLE, AND AGITATOR ASSEMBLY)�
A BLOCK
REPLACEMENT OF CANISTER AND RELATED PARTS
CANOPY COVER
A-15 A-16
To Remove:
The canopy cover has a place on each of the four (4) corners where it is locked in place. 1. Place a very small flat blade screwdriver under the side corner as indicated by the arrow in the illustration, (Fig. 16). Pry out until the corner stays out. After popping this corner loose move the screwdriver to the rear corner on the same side. Place the screwdriver under the canopy cover in the same position as the other end was done. Pry out until the cover is loose on this end. Once the corners are free on one side there is no need to pry on the other side. Raise the cover towards the opposite side until it comes off.
Canopy Cover Ends
A-44 A-2
A-14
2.
A-12 A-13
3. 4.
A-1
A-2
A-13 A-22 A-17 A-18 A-20
(Fig. 16)
5.
A-4 A-19 A-23 A-24 A-26 A-27 A-21
6. 7.
A-25
To Replace:
1. Set the canopy cover in position and rap it down on the two (2) corners closest to the power cord end. Tap the other end down to seat both corners.
