CARE AND CLEANING
BEFORE CLEANING THE APPLIANCE, ALWAYS ALLOW THE COOLING FAN TO COOL THE APPLIANCE DOWN BEFORE SWITCHING OFF AT THE ELECTRICITY SUPPLY. CLEANING MATERIALS
Before using any cleaning materials on your appliance, check that they are suitable and that their use is recommended by the manufacturer. Cleaners that contain bleach should NOT be used as they may dull the surface finishes. Harsh abrasives should also be avoided.
CLEANING THE OUTER AND INNER DOOR GLASS PANELS
To prevent damaging or weakening the door glass panels avoid the use of the following: · · · · · · Household detergents and bleaches Impregnated pads unsuitable for nonstick saucepans Brillo/Ajax pads or steel wool pads Chemical oven pads or aerosols Rust removers Bath/Sink stain removers
CLEANING THE BRASS HANDLES AND CONTROLS
PLATED
The outer grill and oven door glass panels are removable for cleaning.
(WHERE APPLICABLE) It is strongly recommended that only hot soapy water is used for cleaning the handles and controls. ANY OTHER CLEANING MATERIALS WILL DULL THE BRASS PLATED FINISH.
TO REMOVE THE OUTER GLASS
1. Open the grill or oven door slightly to gain access to the two cross head screws on the top of the oven door. 2. Loosen the two screws using a Pozidrive screwdriver.
CLEANING APPLIANCE
THE
OUTSIDE
OF
THE
DO NOT use abrasive cleaning materials or scourers on the outside of the appliance as some of the finishes are painted and damage may occur. Regularly wipe over the control panel and oven doors using a soft cloth well wrung out in warm water to which a little liquid detergent has been added. Any spillage on the stainless steel finish must be wiped off immediately. Stainless Steel cream cleaners are abrasive and should be avoided as they may dull the surface finish.
3. Hold the door glass securely in place with one hand remove the screws and washers with the other hand. The screws and washers retain the trim on the top of the grill door. Note the position of the trim on the door. 4. Holding the door and glass with one hand, gently pull towards you and slightly lift the door glass with the other hand to disengage the panel from the location point at the bottom of the door. Gently release the door to close it. 5. Clean the outer and inner glass using hot soapy water or Hob Brite. Should the inner face of the outer door glass be heavily soiled it is recommended that soapy water with a high concentration of soap is used. To prevent streaking a glass cleaning spray may be applied and the glass polished with a soft cloth. Ensure that all parts are thoroughly dry before attempting to replace the outer door glass.
Do not attempt to remove any of the control knobs from the appliance as this may cause damage and is a safety hazard.
