SHARP MDM2H
Instrukcja Obsługi

SETTING THE CLOCK
In this example, the clock is set for the 24-hour (0:00) system.

7Press the ENTER button.
DISC TOC TRACK MEMORY RANDOM TOTAL REMAIN kHz REC MHz SLEEP

2 4,6,8 1

8 Adjust the minutes by pressing the
3,5,7,9
button.
DISC TOC TRACK MEMORY RANDOM TOTAL REMAIN kHz REC MHz SLEEP

or

q When the button is pressed once , the time will increase by 1 minute. When the button is pressed once, the time will decrease by 1 minute. q The hour setting will not advance even if minutes advance from "59" to "00".

1 Press the ON/STAND-BY button to turn the
power on.

9 Press the ENTER button.
DISC TOC TRACK MEMORY RANDOM TOTAL REMAIN kHz REC MHz SLEEP

2 Press the CLOCK button.
DISC TOC TRACK MEMORY RANDOM TOTAL REMAIN kHz REC MHz SLEEP

q The clock starts operating from "0" seconds. (Seconds are not displayed.)

3 Within 5 seconds, press the ENTER button.
DISC TOC TRACK MEMORY RANDOM TOTAL REMAIN kHz REC MHz SLEEP

To see the time display:

Press the CLOCK button. q The time display will appear for about 5 seconds even if stand-by mode. Note: q The clock display will flash on and off at the push of the CLOCK button when the AC power supply is restored after a power failure occurs or after the AC power lead is disconnected. If this happens, follow the procedure below to change the clock time.

4 Press the
display mode.
DISC TOC TRACK MEMORY RANDOM TOTAL REMAIN

or

button to select the time

"0:00"

�The 24-hour display will appear.

�(0:00 - 23:59) "12:00 AM" �The 12-hour display will appear. �(AM or PM 12:00 - 11:59)

To change the clock time:

"0:00 AM" �The 12-hour display will appear. �(AM or PM 0:00 - 11:59) q Note that this can only be set when the unit is

1 2 3 1 2

Press the CLOCK button.

first installed or it has been reset (see page 48).

Perform steps 6 - 9 above.

Within 5 seconds, press the ENTER button.

To change the time display mode:
Reset the microcomputer (see page 48). Perform steps 1 - 9 above.

5 Press the ENTER button.
DISC TOC TRACK MEMORY RANDOM TOTAL REMAIN kHz REC MHz SLEEP

6 Adjust the hour by pressing the
DISC TOC TRACK MEMORY RANDOM TOTAL REMAIN kHz REC MHz SLEEP

or

button.

q When the button is pressed once, the time will increase by 1 hour. When the button is pressed once, the time will decrease by 1 hour. q When the 12-hour display selected, � AM � will change to � PM � automatically.

9