SHARP MDMT18H
Instrukcja Serwisowa

MD-MT15/15C/15H/15W/161E/18H

NOTES ON SCHEMATIC DIAGRAM
� Resistor: To differentiate the units of resistors, such symbol as K and M are used: the symbol K means 1000 ohm and the symbol M means 1000 kohm and the resistor without any symbol is ohm-type resistor. Besides, the one with �Fusible� is a fuse type. � Capacitor: To indicate the unit of capacitor, a symbol P is used: this symbol P means micro-micro-farad and the unit of the capacitor without such a symbol is microfarad. As to electrolytic capacitor, the expression �capacitance/withstand voltage� is used. (CH), (TH), (RH), (UJ): Temperature compensation (ML): Mylar type � The indicated voltage in each section is the one measured by Digital Multimeter between such a section and the chassis with no signal given. � Parts marked with � �( ) are important for maintaining the safety of the set. Be sure to replace these parts with specified ones for maintaining the safety and performance of the set.
REF. NO SW401 SW402 SW403 SW902 EJECT HOLD DISC LID OPEN DISC PROTECT DESCRIPTION POSITION OFF�ON OFF�ON OFF�ON OFF�ON

B (G) (3) E (S) 1

TOP VIEW TOP VIEW 2SA17457 2SC4213 B RN1103
C (D) (2)

TOP VIEW

1SS361

SB10015 C

TOP VIEW

TOP VIEW

TOP VIEW

1SS372

1SS360

SBE803 2SA1873 GR

Figure 11 TYPES OF TRANSISTOR AND DIODE

� 11 �