SHARP MDMT821H
Instrukcja Serwisowa

ERROR MESSAGES

Error messages Meaning Remedy
replace alkaline battery (or use the (Lo BATT)

The run down. q Charge the rechargeable battery or BATT EMPTY

AC adaptor for power).

BLANK DISC Nothing is recorded. q Replace the disc with a recorded disc. (BLANK) Can�t COPY No copy can be made because of q Record using the analog cable.
and then try editing it.

SCMS copyright system. (Not REC)

Can�t EDIT A cannot be edited. q Change stop position of the track

Recording cannot be performed q Re-record or replace it with another Can�t REC

(Not REC) the unit.

correctly due to vibration or shock in recordable disc.

Can�t WRITE Editing is impossible. q Check the number of tracks.
q Replace the disc with another (DEFECT) recordable disc.

DEFECT recording again.

The disc scratched. q If the sound you hear is not right, try

Din UNLOCK Poor connection of cable. q Connect the digital cable securely. (UNLOCK)

DISC FULL

The disc is out of recording space. q Replace it with another recordable disc.

The unit is in hold mode. q Return the HOLD switch to its original (HOLD) position. LOCKED The EJECT lever was moved during q Turn off power and remove the

recording or editing. MiniDisc. LOCK ERROR

NO DISC A disc has not been loaded. q Load a disc.

�7�

PB DISC disc.

You tried to record on playbackonly q Replace it with a recordable disc.

POWER ? sources.

Improper is being supplied. q Use one of the specified power

The MD is protected. q Move the write protection knob back to q You tried to record without loading an its original position.

A playback-only MD was loaded and q Replace it with a recordable MD.

q Load a recordable MD. PROTECTED

REC button was pressed when the power was off.

READ ERROR The is damaged. q Reload the disc or replace it. (E-READ) q Replace it with another recorded disc.

Since track number is currently being q Wait for a while and try the operation SORRY

(SORRY) accept your command.

located or written to, the unit cannot again.

SYSTEM ERR You come conclusion that q To have it repaired, go to the distributor (E-SYS) unit is out of order. where you purchased the unit. TEMP OVER The temperature is too high. q Turn off the power, and wait for a while. (E-TEMP) TOC ERROR A large portion of the disc has been q Replace it with another recorded disc. (E-TOC) damaged.

There is no space left for recording q Replace it with another recordable disc.

TOC FULL character information (track names,

disc names, etc.).

being erased. it was recorded.

The has been protected from q Edit track with the device on which Tr. Protect

U TOC ERROR A large portion of the disc has been q Replace it with another recorded disc.

(E-UTOC) q There is an error in the recorded signal. try recording again.

damaged. q Erase all of the signal errors, and then

? DISC music was cannot be played.

other than q A disc which contains non-music data

There is an error in signal from the q Replace it with another recorded disc. (?DISC)

disc.

MD-MT821H

( ): Error messages seen on the remote control.