SHARP MDMT831HGL
Instrukcja Serwisowa

Error messages Meaning Remedy

ERROR MESSAGES
POWER ? sources. Improper is being supplied. q Use one of the specified power

Error messages Meaning Remedy replace the alkaline battery (or use
to its original position. (Lo BATT) the AC adaptor for power). q You tried to record without loading

The MD is protected. q Move the write protection knob back PROTECTED and the REC button was pressed (BLANK) when the power was off. an MD q Load a recordable MD.

The is run down. q Charge the rechargeable battery or BATT EMPTY

BLANK MD Nothing is recorded. the disc recorded disc. A playback-only MD was loaded q Replace it with a recordable MD.

Can�t COPY No copy can be made because of q Record using the analogue cable.
being located or written to, the unit tion again. (SORRY) cannot accept your command.

SORRY

the SCMS copyright system. (Can�t C) Since track number is currently q Wait for a while and try the operaA cannot be edited. q Change stop position of the track

Can�t EDIT
TEMP OVER The temperature is too high. q Turn off the power, and wait for a There is an error in recording sigq Erase all of the signal errors, and TOC FORM**

(Can�t E) and then try editing it.

The recordable time is shorter than q Record after you check the remainwhile. Can�t FADE (TEMP!)

the fading time ing recording time. Can�t A.F q Replace it with another recorded disc. (Can�tS)
TOC FULL character information (track names, disc. (Can�tU) disc names, etc.).

The is damaged. q Reload the disc or replace it. (T form**) nal then try recording again. Can�t READ*

(Can�T) There is no space left for recording q Replace it with another recordable

Can�t REC Recording cannot be performed corq Re-record or replace it with another

being Tr. Protect erased. which it was recorded.

rectly due to vibration or shock in unit. recordable disc. The has been protected from q Edit track with the device on (Can�t R)

Can�t STAMP Editing is impossible. q Check the number of tracks. correctly to a MiniDisc.(A large porcordable disc.
the disc.

�7�
DEFECT
* : Number or Symbol. (DEFECT) q Replace the disc with another re-

? DISC music was data cannot be played. (? DISC) There is an error in the signal from q Replace it with another recorded (can�tW) tion of the disc has been damaged.)

Cannot save TOC information Replace the disc with another redata other than q A disc which contains non-music Can�t WRITE

recording again. cordable disc.

The disc scratched. q If the sound you hear is not right, try ( ) : Error messages seen on the remote control.

DISC FULL s Checking remaining amount disc. q When the battery has run completely out,

The disc is out of recording space. q Replace it with another recordable

CONVENIENT OPERATION OF THE UNIT
of battery charge �BATT EMPTY� (main unit) and �Lo BATT�
is shown by the battery indicator ( )

Er-MD** You come conclusion q To have it repaired, go to distribu(remote control unit) will appear. Then, the

that unit is out order. tor where you purchased the unit. The remaining amount of battery charge power will be disconnected automatically. (ErMD*) (HOLD)

Battery indicator q When using the unit with an alkaline bat-

HOLD

Notes: The unit is in hold mode. q Return the HOLD switch to its origiduring operation.

tery or a rechargeable battery, the battery

nal position.
indicator will not correctly display the remain< How to read the battery indicator > q When the AC adaptor included with this unit or a separately available car adaptor is When the battery Charging is q The number of bars shown in the battery indicator may increase or decrease, dePoor connection of cable. q Connect the digital cable securely. This is normal. (noSIG.) external unit playback. to prevent sound skips,deactivate it. kaline are used at same time, When the battery needs charging, it is
impossible to start recording or editing. the rechargeable battery is used first, then PLAY MD You tried to record on playbackq Replace it with a recordable disc.

LOCKED The OPEN lever was moved during q Turn off power and remove the ing capacity for approximately 20 seconds (Can�t LOCK) recording or editing. MiniDisc. after the power has been turned on.

NO DISC A disc has not been loaded. q Load a disc. completely charged needed. used, the battery indicator will not be shown.

NO SIGNAL No output signal comes out from q If the portable CD player has a function pending on the operation being performed. q Playback with the connected unit. q When rechargeable battery and the al-

(PLAY md) q When is completely discharged, Since battery indicator shows the rewhole indicator will flash. Remaining amount of the particular battery

the alkaline battery. only disc.

MD-MT831H/W

( ) : Error messages seen on the remote control. being used, number of bars will incharge battery or replace the alkaline

* : Number or Symbol. crease when unit switches to the albattery with a new one.

kaline battery.