4-3. SCHEMATIC DIAGRAM � Refer to page 13 for IC Block Diagrams.
Note: � All capacitors are in µF unless otherwise noted. pF: µµF 50 WV or less are not indicated except for electrolytics and tantalums. � All resistors are in � and 1/4 W or less unless otherwise specified. � f : internal component. � C : panel designation. � U : B+ Line. � H : adjustment for repair. � Power voltage is dc 3 V and fed with regulated dc power supply from battery terminal.
NJM2113V-TE2
NJM2113V-TE2
� Total current is measured with POWER ON (no-signal) mode. � Voltage is dc with respect to ground under no-signal condition. no mark : POWER ON � Voltages are taken with a VOM (Input impedance 10 M�). Voltage variations may be noted due to normal production tolerances. � Signal path. J : RF F : ANALOG
