6 7 8 9
When �TOC� flashes in the display
The recorder is currently updating the Table Of Contents (TOC). Do not turn off the power, move the recorder, or pull out the AC power cord, while �TOC� is flashing. Changes to an MD made through recording are saved only when you update the TOC by ejecting the MD.
Press r. The recorder stands by for record. When recording the analog input signal, adjust the recording level with REC LEVEL. The fourth dot is satisfactory for most purposes. For details, refer to �Adjusting the Recording Level� on page 11. Press · or P. Recording starts. Start playing the program source.
Do not turn off the power or disconnect the recorder from the power source immediately after recording. If you do, recorded material may not be saved to the MD. To save the material, after recording, press § EJECT to take out the MD. �TOC� will flash in the display at this time. After �TOC� stops flashing and is unlit, you can turn off the power or pull out the AC power cord. To
Stop recording Pause recording* Take out the MD
Press
p P. Press the button again or press · to resume recording. § EJECT after stopping recording
* Whenever you pause recording, the track number increases by one. For example, if you paused recording while recording on track 4, the track number increases by one and recording continues on the new track when restarted.
To protect an MD against accidental erasure
To make it impossible to record on an MD, slide the tab in the direction of arrow, opening the slot. To allow recording, close the slot.
Rear of the disc Record-protect tab
Basic Operations
Slide the tab in the direction of arrow
Note
If you switch REC MODE during recording or recording pause, recording stops.
