Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 13 (kliknij aby zobaczyć)
Getting Started
Step 1: Inserting batteries into the Remote Control
3 1 2
Step 2:
Setting up the TV
E n g l i s h
IMPORTANT! Make sure you have completed all the necessary connections. (See page 8-9 �Connecting TV�).
1 Turn on the TV and set to the correct
video-in channel. You should see the DVD background screen on the TV.
1 Open the battery compartment. 2 Insert two batteries type R03 or AAA,
following the indications (+-) inside the compartment.
2 Usually these channels are between the
lowest and highest channels and may be called FRONT, A/V IN, or VIDEO. See your TV manual for more details. � Or, you may go to channel 1 on your TV, then press the Channel down button repeatedly until you see the Video In channel. � Or, the TV Remote Control may have a button or switch that chooses different video modes. � Or, set the TV to channel 3 or 4 if you are using an RF modulator. audio system or receiver), turn it on and select the appropriate input source for the DVD Player output. Refer to the equipment owner�s manual for detail.
3 Close the cover.
Using the Remote Control to operate the Player
1 Aim the Remote Control
TANDBY ON
DVD VIDEO / CD
IR
STOP PLAY/PAUSE PLAY/ PAUSE OPEN/CLOSE
directly at the remote sensor (iR) on the front panel.
3 If you are using external equipment, (eg.
2 Do not put any objects
between the Remote Control and the DVD Player while operating the DVD Player.
CAUTION! � Remove batteries if they are exhausted or if the Remote Control is not being used for a long time. � Do not use old and new or different types of batteries in combination. � Batteries contain chemical substances, so they should be disposed properly.
