|
|
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
Dobrej jakości skan - wkońcu mogłem poznać wszystkie funkcje tego odtwarzacza - polecam .
;
Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
To set another station to an existing preset number
Listening to the radio
� Preset Tuning
Preset radio stations in the tuner�s memory first (see �Presetting radio stations� on page 12).
Start over from step 1. After step 3, press . or > (or PRESET � or + on the remote) repeatedly to select the preset number you want to store the other station. You can preset a new station in the selected preset number.
To erase a preset station
1 Press TUNER/BAND repeatedly to
select �FM� or �AM�.
1 Press and hold TUNER MEMORY on the
remote until a preset number appears in the display.
2 Press . or > (or PRESET � or + on
the remote) repeatedly to tune in the desired preset station.
Preset number Frequency*
2 Press . or > (or PRESET � or + on
the remote) repeatedly to select the preset number you want to erase.
* When only one station is preset, �ONE PRESET� appears in the display.
Select �ALL ERASE� when you want to erase all the preset stations.
To listen to non-preset radio stations
3
Press ENTER on the remote. �COMPLETE� appears.
Use manual or automatic tuning in step 2. For manual tuning, press m or M (or TUNING � or + on the remote) repeatedly. For automatic tuning, press and hold m or M (or TUNING � or + on the remote).
Tips
When you erase a preset number, the preset number decreases by one and all preset numbers following the erased one are renumbered.
To change the AM tuning interval (except for the European and Middle Eastern models)
The AM tuning interval is factory-set to 9 kHz (10 kHz in some areas). To change the AM tuning interval, tune in any AM station first, then turn off the system. While holding down TUNER/BAND, turn the system back on. When you change the interval, all the AM preset stations are erased. To reset the interval, repeat the same procedure.
Tip
� When an FM stereo program has static noise, press STEREO/MONO repeatedly until �MONO� appears. There will be no stereo effect, but the reception will improve. � To improve broadcast reception, adjust the supplied antennas.
CD/Tuner
The preset stations are retained for half a day even if you unplug the power cord or if a power failure occurs.
13
|
|
|
> |
|
