WHIRLPOOL MLZ8505ADH
Instrukcja Obsługi

USING THE COOKTO =
The surface burners will featureeither matchlit ignitionor Piezo pilotlessignition. e sureallcontrol nobsareinthe B k OFFpositionbeforesupplyinggasto the appliance.Besure gas supply to appliance is on before lighting burner. � To light surface burner with Piezo ignition: 1. Place a pan on the burner grate. 2. Push in and turn the surface burner control knob to the LITE position. IMPORTANT: Only light one surface burner at a time. 3. Immediately, rotate the TOP BURNER IGNITOR knob to the right (clockwise)several clicks until the burnerlights.The burnershould light within 6 clicks or one full rotationof the knob.

To prevent damageto the cooktop or pan: � Never operate the surface burner without a pan in place_ � Never allow a pan to boil dry. � Never operate a surface burner on HIGH for extended periodsof time. CAUTION: If the burner does not light within about 4 secondsor if the flame shouldgoout during cooking,turn the burner off. If gas has accumulatedand a strong gas odor is detected,open a windowand wait 5 minutesfor the gas odor to disappear before relighting the burner, If the appliance has not been operated for a period of time, the surface burnermay bedifficultto lightdue to airin the gas line. To bleed off air from the line: 1. Holda lightedmatchnextto the burner, 2. Turnthe surface burnercontrol knobto the LITEposition. 3. When the burner lights, turn the knob back to the OFF position. 4. Proceedas directed below. To lightsurface burnerwith matchlit ignition: 1. Placea pan on the burner grate. 2. Hold a lighted match next to the desired surface burner head. CAUTION:Do not turnthe controlknob on and allow gas to escapebefore lightingthe match. 3. Push in and turn the surface burner control knob to the LITE position. 4. When the burner lights, adjust the knob betweenHIand LOWto selectthe desiredflame size. 5. After cooking,turn the surface burner controlknob to the OFF position.

L"

4. When the burner lights, adjust the surface desire( controlknob between HI and LOWto selectthe burne flame size.

5. After cooking,turn the surface burner control knob to tl" OFF position. To operate burner if the Piezoignitor is not functiona 1, Be sureallcontrolsarein the OFF position. 2. Hold a lighted matchto the desired surface burner heac CAUTION:Do not turn the controlknobon and allow gas to escape before lighting the match. 3. Push in and turn the surface burner control knob to th LITE position. 4. When the burner lights, adjust the knob between HI an LOW to select the desired flame size. 5. After cooking,turn the knob to the OFF Position.

Whenthe recreationalvehicle isnot in useor while travelin( turn all knobs to the OFF positionand turn off the main ga supply.