E-MU MP-7
Instrukcja Obsługi

Preset Programming Editing Presets

L1

FILTER

Ord 4

Type LPF

Classic



Front panel knobs 1-2 are routed to the �lter parameters and will affect the initial settings made here. You may want to disconnect the PatchCords to gain total control over the �lter parameters.

2.

Go to the Filter Frequency and Q screen. Position the cursor in the Freq: �eld as shown in the following illustration.

L1

FILTER 255 Q: 000

Freq:

The Frequency parameter determines the �lter cutoff frequency or the frequency the �lter uses as the highest frequency allowed to pass. If you play the keyboard now, you should hear the raw sound. Slowly decrease the �lter cutoff frequency value as you play the keyboard. The sound gets more and more dull as you remove more and more high frequencies from the sound. At some point, the sound completely disappears. (You have �ltered out everything.) The chart on the following page illustrates what you just did.

100 80

Cutoff Frequency
Output of Filter

Amplitude

60 40 20

40

80

160 360 720 1440 2880 ...

Frequency
3. 4.

5.

Open the �lter back up to 255, then move the cursor to the Q �eld. Set the Q to 10, then move the cursor back under the Freq value. As you change the frequency, notice that the sound now has a sharp, nasal quality. A high Q boosts or ampli�es the frequencies at the cutoff frequency (Fc). Reset the cutoff frequency to the lowest setting and the Q to 00.

284 E-MU Systems