The range and default values for the parameters are shown below.
To record the signal processed by the send/return effect on a track, you can use bounce recording while the respective [INPUT 1]/[INPUT 2] key is on (� p. 39).
Press the [CHORUS/DELAY] key or [REVERB] key to select a patch for the send/return effect.
The display changes and shows the currently selected patch of the selected effect (chorus/delay or reverb).
HINT When the send level is shown on the display, pressing the [ENTER] key will turn the signal output to the send return
2.
Turn the dial to select the patch you want to use.
effect off. Pressing the key once more will turn the signal on again.
You can also select a patch by using the PATCH SELECT [Q]/[W] keys in the effect section. When you have selected the patch, press the [EXIT] key to return to the main screen.
6.
When you have �nished making settings, press the [EXIT] key.
The unit returns to the main screen.
3.
Press the [TRACK PARAMETER] key in the track parameter section and use the cursor up/down keys to bring the following indication onto the display.
Adjusting the pan/balance
This section explains how to adjust the pan (stereo position) of the signal sent from the input mixer to the MASTER OUTPUT jacks and the recording tracks, or the balance (the volume balance between two channels).
� To adjust the chorus/delay send level
TR1 CHO SEND
Parameter
1.
0
Press the [TRACK PARAMETER] key in the track parameter section and use the cursor up/down keys to bring the following indication onto the display.
Setting value
� To adjust the reverb send level
TR1 PAN TR1 REV SEND
Parameter
0
0
2.
Press the [INPUT 1] or [INPUT 2] key in the input section.
Setting value
4.
Press the [INPUT 1] or [INPUT 2] key in the input section.
The input mixer (INPUT) is selected as target for panning adjustment.
The input mixer (INPUT) is selected as target for setting the send level.
INPUT PAN
3.
0
INPUT CHO SEND
5.
Turn the dial to edit the value of the PAN parameter.
0
The PAN parameter can be adjusted in a range of L100 (far left) - 0 (center) - R100 (far right).
Turn the dial to select the effect depth.
Higher values result in more effect depth (stronger effect).
