|
|
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
Dokładna dokumentacja, pomogła w szybkiej naprawie telewizora. Dziękuję!
 ;
jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
;
Wszystko w porządku.
Instrukcja czytelna i kompletna.
Dziękuję.
all right!
thank you.
;
Bardzo dobra instrukcja. Zawiera wszystko co potrzeba, polecam!
;
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
5-1-4. Basic Knowledge
5-1-4. Basic Knowledge
1. Tape Cleaner c Never touch the edge of the tape cleaner with bare hands. It is in danger of cutting your finger because the tape cleaner has a sharp edge. Pay careful attention when replacing or adjusting the peripheral parts. 2. Tools Before use a tool, clean the surface of the tool using a cleaning cloth moistened with cleaning fluid. . Cleaning cloth: 3-184-527-01 . Cleaning fluid: 9-919-573-01 Be careful not to damage the tool. If the flawed tool is used, adjustment cannot be performed correctly. 3. Note (1) Grease and Oil Please use only the specified grease and oil. If the different grease or oil is used, major malfunctions may be caused due to differences in viscosity and ingredients. And if the grease or oil that has been mixed with dust is used, major malfunctions may be caused. Use the following grease and oil. . Grease (SGL-505): 7-661-000-10 . Oil: 7-661-018-18 Apply just enough grease to create a thin film on the surface of the part. Any grease that adheres to other surrounding parts must be wipe using a gauze or soft cloth. A drop of oil is defined as follows: About the amount that will adhere to the end of a stick 2 mm in diameter, as shown in the figure. Do not use the grease and oil except for specified portions.
2 mm (diameter) Oil
Oil
(2) Stop Washer and E Ring It should not be used the stop washer and E ring once again. It is recommended checking a required stop washer and E ring before replacement, and preparing more than required number.
5-8
MSW-A2000/A2000P
|
|
|
> |
|
