jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
Tekstowy podgląd strony 16 (kliknij aby zobaczyć)
DISASSEMBLY INSTRUCTIONS
1-5: TOP SHIELD ASS'Y (Refer to Fig. 1-5) 1. Remove the 9 screws 1. 2. Remove the Top Shield Ass'y in the direction of arrow.
4 1
Top Shield Ass'y CD Deck Pick Up PCB
4
1 1 1 1 1 1 1 1
Operation PCB
4 4 3 1 1
(D) Angle Deck Make the short circuit 1 using a soldering.
3
Front Shield
(C)
1
(B) (E) DVD PCB
2 2 5 5 5 5
(A) DVD/VCR Block
Fig. 1-5 Fig. 1-6 1-6: OPERATION PCB/DVD PCB/CD DECK (Refer to Fig. 1-6) 1. Make the short circuit on the position as shown Fig. 1-6 using a soldering. If you remove the Deck CD with no soldering, the Laser may be damaged. 2. Disconnect the following connectors: (CP2201, CP3605, CP8001 and CP8002). 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. Remove the 4 screws 1. Remove the Angle Deck in the direction of arrow (A). Remove the 2 screws 2. Remove the Front Shield in the direction of arrow (B). Remove the 2 screws 3. Remove the Operation PCB in the direction of arrow (C). Disconnect the following connectors: (CP2601, CP2602 and CP2603). Remove the 4 screws 4. Remove the CD Deck in the direction of arrow (D). Remove the 4 screws 5. Remove the DVD PCB in the direction of arrow (E). 1-7: POWER PCB (Refer to Fig. 1-7) 1. Disconnect the following connector: (CP3603). 2. Remove the 3 screws 1. 3. Remove the Power PCB in the direction of arrow.
1 1 1
Power PCB
Bottom Plate Ass'y
NOTE When the installation of the Deck CD, remove all the soldering on the short circuit position after the connection of Pick Up PCB and DVD PCB connector.
