|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
...instruction is ok.
...instrukcja jest ok.
Thanks/Dzięki
;
Documentation made available quickly and It is good quality. Thanks.
MX-DVB9 Removing the cams R1/R2 assembly and cam gear L (See Fig.23)
Slit washer 1. Remove the slit washer fixing the cams R1 and R2 assembly. 2. By removing the two pawls "S" fixing the cam R1, separate R2 from R1. 3. Remove the slit washer fixing the cam gear L. 4. Pull out the cam gear L from the C.G. base assembly. Cam gear L Slit washer Cam R2
11
Pawl S Pawl S Cam R1
Removing the C.G. base assembly (See Fig.23, 24)
Remove the three screws 11 retaining the C.G. base assembly. [Caution] To re-assemble the cylinder gear, etc. with the cam unit (cam gear and cans R1/R2 assembly), gear unit and drive unit, align the position of the pawl "N" on the drive unit to that of the notch on the cam gear L. Then, make sure that the gear unit is engaged by turning the cam gear L (See Fig. 24).
Cam switch board C.G. base assembly
Fig.23
Cam gear L Cam R1, R2 assembly
Notch
Pawl N Cylinder gear
Gear unit
Drive unit
Gear bracket
Fig.24
1-22
|
