JVC MXGT90
Instrukcja Serwisowa

MX-GT80/MXGT90 Removing the tuner board (See Fig.11 and 12)
Prior to performing the following procedure, remove the metal cover and the CD changer mechanism assembly. 1. Disconnect the card wire from connector CN1 on the antenna board on the right side of the body. 2. Remove the plastic rivet fixing the antenna board. 3. Remove the two screws F on the back of the body. Fig.11
Plastic rivet Tuner board Rear panel

CN1

G F
Removing the rear cover / rear panel (See Fig.12 to 15)
Prior to performing the following procedure, remove the metal cover and the CD changer mechanism assembly. 1. Remove the screw G attaching the rear cover on the back of the body. 2. Push each tab of the four joints b in the direction of the arrow and release. 3. Remove the eleven screws F panel. attaching the rear
Rear cover Joint b

Rear panel

Joint b

Fig.12
Rear panel

4. Release the joints c on each lower side of the rear panel using a screwdriver and remove the rear panel backward. Note : Remove the tuner board in case of necessity. (Refer to Fig.21)

F F F F

Fig.13

Joint c

Rear panel

Rear panel

Joint c

Fig.15

Fig.14

1-9