JVC MX-GT90C
Instrukcja Obsługi

Common Operations
Turning On or Off the Power
To turn on the unit, press STANDBY/ON so that the STANDBY lamp goes off.
STANDBY/ON STANDBY

3 Turn 4 / ¢ to adjust the minute, then
press SET/DISPLAY.

To turn off the unit (on standby), press STANDBY/ON again so that the STANDBY lamp lights up.

STANDBY/ON STANDBY

To check the clock time
Press and hold SET/DISPLAY while playing any source. � Each time you press and hold the button, the source indication and the clock time alternate on the display.

A little power is always consumed even while the unit is on standby. To switch off the power supply completely, unplug the AC power cord from the AC outlet.
When you unplug the AC power cord or if a power failure occurs The clock is reset to �AM 12:00� right away, while the tuner preset stations (see page 12) will be erased in a few days.

To adjust the clock again
If you have adjusted the clock before, you need to press CLOCK/TIMER repeatedly until the clock setting mode is selected. � Each time you press the button, the clock/timer setting modes change as follows:
DAILY Canceled ON TIME Clock setting REC ON TIME

(The hour digits start flashing.)

Setting the Clock
Before operating the unit any further, first set the clock built in this unit. You can set the clock whether the unit is on or off.

When you unplug the AC power cord or if a power failure occurs The clock loses the setting and is reset to �AM 12:00.� You need to set the clock again.

Selecting the Sources
To listen to the FM/AM broadcasts, press FM/AM. (See page 12.) To play back CDs, press CD 3¥8. (See pages 13 � 16.) To play back tapes, press TAPE 2 3. (See page 17.) To select the external equipment as the source, press AUX.

On the unit ONLY:

1 Press CLOCK/TIMER.
The hour digits start flashing on the display.

2 Turn 4 / ¢ to adjust
the hour, then press SET/DISPLAY.
The minute digits start flashing on the display. When you press the play button for a particular source (FM/AM, CD 3/8, TAPE 2 3, and AUX), the unit turns on (and the unit starts playing the source if it is ready � COMPU PLAY CONTROL).

If you want to correct the hour after pressing SET/DISPLAY, press CANCEL/DEMO. The hour digits start flashing again.

About the audio level indicator All the audio level indicators light up when no signals come in.

�9�