Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 7 (kliknij aby zobaczyć)
Getting Started
Connecting the AM Antenna
Rear Panel of the Unit
Turn the loop until you have the best reception.
AM loop antenna (Supplied)
Attach the AM loop to its base by snapping the tabs on the loop into the slot in the base.
AM antenna wire (not supplied) If reception is poor, connect the outside antenna.
� Even when connecting an outside AM antenna, keep the indoor AM loop connected.
CAUTION:
� To avoid noise, keep antennas away from the System, the connecting cord and the AC power cord.
Connecting the Speakers
Connect the right speaker to the RIGHT speaker terminals and the left speaker to the LEFT speaker terminals. �Right� /�Left� is labeled on the rear of the speaker. 1. Open each of the terminals to connect the speaker wire leads. 2. Connect the speaker cords to the Speaker terminals of the Unit. Connect the red (+) and black (�) cords of the right side speaker to the red (+) and black (�) terminals marked RIGHT on the System. Connect the red (+) and black (�) cords of the left side speaker to the red (+) and black (�) terminals marked LEFT on the System. 3. Close each of the terminals.
Right side (rear view) Red Left side (rear view)
Black
Red Black
CAUTIONS:
� A TV may display irregular colors if located near the speakers. If this happens, set the speakers away from the TV. � Use speakers with the correct impedance only. The correct impedance is indicated on the rear panel.
