|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
...instruction is ok.
...instrukcja jest ok.
Thanks/Dzięki
;
Documentation made available quickly and It is good quality. Thanks.
CHAPTER 6 FIXING SYSTEM
7. Installing the Fixing Heater Install the heater by reversing the steps used to remove it with the following in mind: a. Do not touch the surface of the heater. b. Orient both heaters so that the sides with longer heater wires are toward the front. c. Install the main heater (600 W) to the right and the sub heater (600 W) to the left when viewing from the front. d. While viewing from the rear of the copier, connect the faston on the right to the main heater and the faston at the top to the sub heater. 8. Removing the Fixing Upper Roller 1) Slide out the fixing/feeding unit from the copier. 2) Remove the fixing/feeding assembly front cover. 3) Open the fixing/delivery assembly. 4) Remove the flywheel. 5) Remove the fixing upper cover, and remove the fixing cleaning belt; then, clean the silicone oil pan, and remove the fixing upper unit. 6) Remove the main heater and the sub heater. 7) Remove the two mounting screws w used to hold the fixing cleaning belt assembly q in place, and release the cleaning belt. 8) Remove the two mounting screws e, and remove the heater holder r at the rear.
w
q
w
Figure 6-215
e
e Figure 6-216
r
COPYRIGHT © 1997 CANON INC.
CANON NP6560/NP6360/NP6260 REV. 0 NOV. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
6-25
|
