AIWA NSXA555
Instrukcja Obsługi

!
;c���

.-.. �

����-

The clock is displayed. (The �:� between the hours and minutes flashes.) When the power cord is plugged into an AC outlet for the first time after purchase or when the clock setting is canceled due to a power failure, the entire clock display flashes.

The unit can be turned off automatically at a specified time, Use the remote control.

1 Press SLEEP while pressing SHIFT.

1 Press CLOCK.
When using the remote control, press CLOCK while pressing SHIFT.

2 Within 4 seconds, turn MULTI JOG to specify the time until the power is turned off.
The time changes between 5 and 240 minutes in 5-minute steps. + and are also available instead of MULTI JOG.

2 Within 4 seconds, turn MULTI JOG to designate the hour and the minute.
Turning MULTI JOG changes both the hour and the minute. + or ~ is also available instead of MULTI JOG. Holding these buttons down will vary the time rapidly.

Specified time

3 Press ENTER or Il.
The clclck starts from 00 seconds. To restore an original clock setting Press CLOCK before completing step 3 to restore the previous time setting. This cancels any new setting. To view tlhe clock when another display is in the display Press CLC)CK. The time is displayed for 4 seconds and then the original display reappears. However, the clock cannot be displayed during recording. To switchl to the 24-hour standard Press the CLOCK and then press s within 4 seconds. Repeat th[? same procedure to restore the 12-hour standard. I If the clock If the display that the clock of the power display flashes I flashes when the clock is displayed, it indicates has stopped due to a power failure or the removal cord. The current time needs to be reset.

While the timer is in operation, the clisplay indication is dimmer than usual. To check the time remaining until the power is turned off Press SLEEP once while pressing SIHIFT. The remaining time is displayed for 4 seconds. To cancel the sleep timer Press SLEEP twice while pressing SHIFT so that �SLEEP oFF appears on the display.

If the power-economizing mode (page 7) is on, all the display lights turn off when the power is turned off. To view the clock, press CLOICK so that the time is displayed for 4 seconds.

18

ENGLISH