Lens Cap and Grip Belt
1
To protect the Lens surface, attach the Lens Cap. Adjust the length of the Grip Belt to the size of your hand.
1 Attach the Lens Cap to the Grip Belt. 2 Put your hand through the Grip Belt and adjust the length. �The removed Lens Cap can be hooked onto the Grip Belt 1.(When you are
2
not recording, be sure to keep the Lens Cap attached to the Lens for protection.)
1
Attaching the Shoulder Strap
1
~~~~~~~~~~~~~~~~~~~~~~~~~
We recommend that you attach the Shoulder Strap before going out of doors to record so as to avoid dropping the Movie Camera.
1 Pull the end of the Shoulder Strap through the Shoulder
Strap Holder on the Movie Camera. 2 Fold the tip of the Shoulder Strap, run it through the Shoulder Strap Length Adjuster, and pull it.
�Pull it out more than 2 cm 1 from the Shoulder Strap Length Adjuster so that it cannot slip off.
2
1
2
Inserting a Cassette
~~~~~~~~~~~~~~~~~~~~~~~~~
When power is supplied to the Movie Camera, the Cassette can be taken out without turning the Movie Camera [ON].
1 Slide the [<EJECT] Lever to open the Cover. 2 Insert a Cassette. 3 Close the Cover and press the [PUSH LOCK] Button to lock
the Cover.
ª Accidental Erasure Prevention
1
<EJECT
3
Opening the accidental erasure prevention slider 1 on the cassette (by sliding it in the [SAVE] arrow direction) prevents recording. To enable recording, close the accidental erasure prevention slider (by sliding it in the [REC] arrow direction). �For other notes concerning this item, see page 39.
