SHARP NX-585
Instrukcja Serwisowa

UX-385TH NX-585TH 3. Assembly and connections

4 Attach the paper tray extension.
� Pull the paper release plate forward. Insert the paper tray extension horizontally into the notches in the paper tray. Rotate the paper tray extension up until it snaps into place.

1Plug the power cord into a 220-240V, 50-60Hz, earthed(2-prong) AC
outlet. � Caution: Do not plug the power cord into any other kind of outlet. This will damage the machine and is not covered under the warranty. The machine does not have a power on/off switch, so the power is turned on and off by simply plugging in or unplugging the power cord.

�

Note: If your area experiences a high incidence of lightning or power surges, we recommend that you install surge protectors for the power and telephone lines. Surge protectors can be purchased at most telephone specialty stores.

5 Attach the original document support.
Note: The original document support has a top side and a bottom side. If you cannot insert the tabs on the support into the holes, turn the support over.

2Connect the handset as shown and place it on the handset rest.

� The ends of the handset cord are identical, so they will go into either socket.

Make sure the handset cord goes into the socket marked with a handset symbol on the side of the machine! Use the handset to make ordinary phone calls, or to transmit and receive documents manually.

4. Loading printing paper
You can load A4 size paper in the paper tray. The maximum number of is: � 60 for paper from 60 to 75 g/m2: � 50 for paper from 75 to 90 g/m2:

3 Insert one end of the line cord into the socket on the back of the
Be sure to insert the telephone line cord into the TEL.LINE socket. Do not insert into the TEL.SET socket. machine marked TEL.LINE. Insert the other end into a wall telephone socket.

1 Fan the paper, and then tap the edge against a flat surface to even
the stack.

TEL SET. TE LI L. NE

1�6