OKI OKIPAGE 10E
Instrukcja Serwisowa

Remove three screws 9 which are holding the guide R (2nd) assy 0 to the bottom plate A. Remove the screw B which is keeping the rear cover C and guide R (2nd) assy 0. Remove the guide R (2nd) assy 0. (7) Remove the protect (M) D, guide bracket E, planet gears F and planet gear bracket G. (8) Remove the E-ring H which is keeping the sheet link I on the guide R (2nd) assy 0, and pull out the hinge stand J. (9) Remove three remaining screws K which are keeping the motor on the motor bracket L, and remove the connector off the Stepping Motor M. (10) Remove two screws N on the Stepping Motor M.

(6)

Detail A

0

I

C

J

K

Q

P

OH N

Note : The guide bracket E must be attached as shown in the following illustration:
No jutting of the gear shaft G is allowed into the oval hole E. Turn

C

L M B E F G

E clockwise for screw C

looseness to affix firmly.

A E 9
The upper plate 3 must be attached as shown in the following illustration.

3

0

9

41154001TH Rev.2

160 /