jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
Wszystko w porządku.
Instrukcja czytelna i kompletna.
Dziękuję.
all right!
thank you.
Tekstowy podgląd strony 149 (kliknij aby zobaczyć)
1
Image are light or blurred a whole.
� Is toner low? (Is the TONER LOW message displayed?) �
w
Yes
Supply toner.
�
No � No
Is paper of the specified grade used? Use paper of the specified grade. Is the lens surface of the LED head dirty? Yes Clean the lens.
w
�
Yes �
w
�
No
Is the LED head installed properly? (Check connector HEAD1 (14P), HEAD2 (12P) of the Main board and PC connector on the LED head for proper connection.) No Install the LED head properly. Is the contact plate of the transfer roller contacted with the contact assembly of the power/sensor board properly? (See Figure 6-6.) No Make the contact plate of the transfer roller contact with the power/sensor board and Shaft of the transfer roller properly. Are the contact of the developing roller and the contact of the toner supply roller of the image drum cartridge contacted with the contact assembly properly? (See Figure 6-5 A and B .) No Adjust the contacts of the developing and toner supply roller to contact the contact assembly properly. Replace the transfer roller. (See 3.3.36.)
�
w
�
Yes
�
w
�
Yes
�
w
� �
Yes
Has the trouble been removed? � Yes End
w
� �
No
Replace the image drum cartridge.
Has the trouble been removed? � Yes End Note: After replacing the image drum cartridge, set the printer in the user maintenance mode by turning the power on while pressing the MENU key and reset the drum counter. (Refer to User's Manual.)
