KORG PA50
Instrukcja Obsługi

Program operating mode
Page 6 - Pitch EG

111

tors is adjusted by the �Intensity (AMS1/2 Intensity)� parameter (see page 14-111).

Pitch EG �Level� modulation
Pitch EG change (level) (AMS=JS-Y/Velocity, Intensity= positive (+) value Note-on Note-off Note-on Note-off Note-on Note-off

Pitch EG
Start Level: Attack Time: Attack Level: Decay Time: +0 39 +0 0
A note played softly with Start Level Swing set at 0, Attack Level Swing set to +, the Joystick pulled on A note played strongly with Start Level Swing set to 0, Attack Level Swing set to +, the Joystick pulled on A note played strongly with Start Level Swing set to 0, Attack Level Swing set to �, the Joystick pulled on

AMS1/2 (L) (Alternate Modulation Source 1/2)

Pitch envelope
Time-varying pitch settings (when Pitch EG Intensity = +12.00) +99 = approximately 1 octave Attack Level Note-on 0 = pitch when key is held (sustained) Note-off

These parameters select the source that will control the pitch EG �Level� parameters (�AMS (Alternate Modulation Source) list� on page 123).
Intensity (AMS1/2 Intensity)

These parameters specify the depth and direction of the effect
Time Release Level

applied by �AMS1�. With a setting of 0, the levels speci�ed by �Start/Attack/Decay/Release Level� will be used. For example if �AMS1� is Joystick +Y, pushing the joystick to turn it on will change the �Level� parameters of the Pitch EG. As the absolute value of �Intensity� is increased, the pitch EG levels will change more greatly when the joystick is released. The direction of the change is speci�ed by �Start Level Swing� and �Attack Level Swing�. When the key pressure is released, the pitch EG levels will return to their own settings. If �AMS1� is set to Velocity, increasing the absolute value of �Intensity� will produce increasingly wider change in pitch EG levels for strongly-played notes. The direction of the change is speci�ed by �Start Level Swing� and �Attack Level Swing�. As you play more softly, the pitch change will draw closer to the pitch EG levels. -99�+99 Parameter value.
Start Level Swing

Start Level Attack Time Decay Time

�99 = approximately 1 octave

Release Time

Start/Attack/Decay/Release Level

These parameters specify the amount of pitch change. The actual amount of pitch change will depend on the �Intensity (AMS1/2 Intensity)� parameter (see below). For example, with an �Intensity� setting of +12.00, a �Level� setting of +99 would raise the pitch one octave, and a �Level� setting of �99 would lower the pitch one octave. -99�+99 Parameter value.
Start Level

Speci�es the amount of pitch change at note-on.
Attack Level

Speci�es the amount of pitch change when the attack time has elapsed.
Release Level

Speci�es the amount of pitch change when the release time has elapsed.
Attack/Decay/Release Time

This parameter speci�es the direction of change in �Start Level� caused by �AMS1/2�. If �Intensity� is a positive (+) value, a setting of + will raise the EG level, and a setting of � will decrease it. With a setting of 0 there will be no change.
Attack Level Swing

These parameters specify the time over which the pitch change will occur. 0�99 Parameter value.
Attack Time

This parameter speci�es the direction of change in �Attack Level� caused by �AMS1/2�. If �Intensity� is a positive (+) value, a setting of + will raise the EG level, and a setting of � will decrease it. With a setting of 0 there will be no change.

Speci�es the time over which the pitch will change from note-on until it reaches the pitch speci�ed as the attack level.
Decay Time

Pitch EG �Time� modulation
Pitch EG changes (Time) (AMS = Velocity, Intensity = positive (+) value) Note-on Note-off Note-on Note-off Note-on Note-off

Speci�es the time over which the pitch will change after reaching the attack level until it reaches the normal pitch.
Release Time

Speci�es the time over which the pitch will change from note-off until it reaches the pitch speci�ed as the release level.

A note played softly with Attack A note played strongly with A note played strongly with Time Swing set to + and Attack Time Swing set to + and Attack Time Swing set to � and Decay Time Swing set to + Decay Time Swing set to + Decay Time Swing set to �

AMS(T) (Alternate Modulation Source)

This parameter selects the source that will control the �Time� parameters of the pitch EG (see �AMS (Alternate Modulation Source) list� on page 123).
Intensity (AMS(T) Intensity)

This parameter speci�es the depth and direction of the effect that �AMS� will have on the �Time� parameters. With a set-