2-3 Loading the Tape
Tape reels to be used
Use 14-inch, 12.5-inch or 10-inch tape reels and empty reels.
4 5
Turn the take-up reel to eliminate slack. Press the tension disarm switch or the STOP button of the PCM-3348HR.
Loading the tape
Chapter 2
Use the following procedure to load the tape.
This applies tension, and the tape is then in the loaded state. The STOP button changes from flashing to continuously lit.
Caution
1
Aligning the reels so that the slot in the hub fits over the projection on the spindle, mount the tape reel and empty reel.
If there is slack in the tape when it is loaded, this can cause damage to the tape or the tension arms. Recording the whole length of a previously used tape or using the tape reversed In these cases it is essential to use advance recording, or to prestripe the tape before use.
ITAL DIG
Fit the slot over the projection
S
ONY
2 3
Turn the spindle knob clockwise until it stops to fasten the reel. Thread the tape as shown in the figure.
