Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 18 (kliknij aby zobaczyć)
Attaching the unit stand
The unit stand allows you to place your Access Point in an upright position. When the unit stand is attached, wire cables are routed through the recessed groove.
Before attaching the unit stand
Make sure to write down the six-digit Access Point ID on the label attached on the bottom surface of the Access Point. Access Point ID
Note
Category 5 Ethernet cable is recommended or you may not be able to attach the unit stand to the Access Point.
Attach the unit stand to the Access Point as shown in the figure below. Engage Joint A with Joint B and slide the Access Point in the direction indicated by the arrow until it clicks.
Joint A
Joint B
Groove z Tip
The unit stand may be attached in either direction.
To remove the unit stand
Slide the Access Point and unit stand in opposite directions to detach.