CONNECTIONS TIMER PLAYBACK
By using a commercially available audio timer, it is possible to initiate playback at any time automatically. 1. Turn on the power to the player, load a disc into the disc tray and close the disc tray with OPEN/CLOSE button. 2. Set the time at which you wish playback to begin. The timer will supply power to both the amplifier and the player at the preset time, turning all the components on and initiating the playback mode. Playback starts from the first track.
NOTES: ÷ If no disc has been loaded in the player, the player will enter the standby mode when the audio timer turns the player's power on. ÷ Pressing any function buttons before commencement of timer start cancels the timer start function.
System remote control with a Pioneer stereo amplifier that has the � mark (PD-117 only)
When a Pioneer stereo amplifier bearing the � mark is used, connect the CONTROL IN jack on the rear panel of the CD player to the CONTROL OUT jack of the amplifier. This will enable the CD player to be controlled using the remote control unit supplied with the stereo amplifier. If you do not plan to use this feature, it is not necessary to connect CONTROL IN/OUT jacks. ÷ The control cable is supplied with the CD player. ÷ The remote control unit supplied with the amplifier can be used to control Play, Stop, Pause and Track Search. ÷ For instructions regarding connections and operation, refer to the Operating Instructions provided with your stereo amplifier.
NOTES FOR PD-117: ÷ When a control cable is connected to the player's CONTROL IN jack, direct control of the player with the remote control unit is not possible. Operate the player with the remote control unit by aiming it at the amplifier. ÷ Be sure to connect both of the control cable's plugs securely to the CONTROL IN and CONTROL OUT jacks. Do not connect only one end of the cable. ÷ Be sure to turn off the power of the amplifier when connecting the power cord and output cable.
