jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
Tekstowy podgląd strony 27 (kliknij aby zobaczyć)
METHOD OF ADJUSTMENTS
â� Adjusting conditions
Adjustments should be carried out in the procedures of A to D specified below. However, any adjustments other than the items A to D below are not required. A. B. C. When the �PDP module� is replaced, adjustments should conform to the adjusting items of [1 and 2] specified below. When the �POWER UNIT� is replaced, adjustments should conform to the adjusting item of [2] specified below.
â� Adjusting items 1. Clearing of the usage time (Using the remote control)
When the �MAIN PWB� is replaced, adjustments should conform to the adjusting item of [3] specified below. D. When the "HIGH VOLTAGE PWB" is replaced, adjustments should conform to the adjusting item of [4] specified below.
(1) Press the keys in the order of [MENU] [MUTE] [EXIT] [SLEEP] [EXIT] in order to enter the diagnostics menu. (2) Press the [MENU/ENTER] key to select the [USAGE TIME] menu (8/11). Then, the integrated time [34567 (hours)] (example) accumulated till the present time is displayed when the main power supply is turned on (except for the standby mode).
USAGE
TIME
34567H
232C-ALARM
RX TX
0 0
[MENU/ENTER] NEXT
[EXIT] PREV
8/11
(3) When the keys are pressed in the order of [MUTE] � POSITION/CONTROL [ ]� POSITION/CONTROL [ ] � [SLEEP], the display is cleared to [00000H]. At that time, the characters of [RESET] are displayed for about 5 seconds on the right side of time display.
