7 Installation procedure
1
Remove the special screws (2 locations) from the bottom of the hung on wall unit.
4
Fix the plasma display to the PDP side hardware with bolt M8 (6 locations). Usually, use the holes marked with the red triangle "%". If the 43-inch model is installed with an inclination of 18° or more, the top part of the screw used to adjust the angle may be visible from a horizontal position in front of the screen. In this case, you can hide the top of the screw by using the holes without a red triangle mark �%�.
Special screws (M6)
2
Remove the hardware on the wall side and the hardware on the PDP side.
Wall side hardware Top side of plasma display
Warning
PDP side hardware
3
Attach the PDP side hardware to the plasma display.
Warning
Be sure to install the speaker at this stage. � For the installation method, refer to the speaker installation procedure in the plasma display instruction manual or the under speaker instruction manual. � To install the under speaker in particular, first attach hang the plasma display on the wall with only the speaker installation hardware and the speaker cord attached, then attach the under speaker. Refer to the under speaker operating instructions for the method of attaching the speaker installation hardware and the speaker cord.
� Cover the display with a sheet or similar protective material to protect it from scratches or other damage. � Be sure to attach it on top of a flat table or similar surface.
Plasma display PDP side hardware
