Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 21 (kliknij aby zobaczyć)
BASIC OPERATION
WHEN USE MULTIPLE MONITORS
When you use multiple Plasma Monitors, you can use POWER ON button and POWER OFF button on Remote Control Unit instead of the POWER ON-OFF button. Press POWER ON button to turn Plasma Monitor ON so as not to affect another Plasma Monitor which may be already turned ON.
F OK STATUS
MOVE DOWN MENU
POWER ON
POWER ON button POWER OFF button
Press POWER OFF button to turn Plasma Monitor OFF (standby mode) so as not to affect another Plasma Monitor which may be already turned OFF (standby mode) .
OFF
OFF TIMER
The OFF TIMER can be set to turn the power off after 30, 60, 90 or 120 minutes.
Pressing the OFF TIMER button on the Remote Control Unit until desired time is displayed.
INPUT VIDEO COMPONENT ON-OFF
OFF TIMER button
PC/RGB
VOLUME
Off timer 30
30
60
90
120
0
WIDE
OFF TIMER
PICTURE
MOVE UP
MUTE
When remaining time reaches zero, "Off timer 0" appears for 10 seconds, then Plasma Monitor turns to OFF (standby mode).
TO CHECK THE REMAINING TIME:
To check the remaining time of OFF TIMER set, press OFF TIMER button once. The remaining time displayed for few seconds. When you select input signal, the remaining time is displayed below the input mode.
Off timer 58
AV1 58
TO CANCEL THE OFF TIMER:
Pressing the OFF TIMER button until the time "0" is displayed.
