PIONEER PDP-5071PU
Instrukcja Serwisowa

1

2

3

4

DELAY ADJUSTMENT OF THE CONTROL SIGNAL (SUS-D)
A

1 Measure the pulse width of the SUS-D signal. 2 Check the pulse width of the SUS-D input signal for the DK module. Adjust the variable control so that the pulse width of the SUS-D input signal for the DK module becomes the "pulse width of the SUS-D signal ± 5 nsec." Note: For details on measuring points of waveform, see the figure below.

SUS-D pulse width Tsus-D
B

50 % of the crest value SUS-D signal (input to the DRIVE Assy)

50 % of the crest value

SUS-D pulse width Tsus-Dg

50 % of the crest value
C

50 % of the crest value

SUS-D signal (input to the DK module)

D

SUS-D pulse width: Tsus-Dg Adjust so that "Tsus-Dg = Tsus-D ± 5 nsec," using the variable control shown in the table below:

Assy Y MAIN DRIVE

VR VR2002

E

F

126
1 2

PDP-5071PU
3 4