Additional Recording Features
Checking What's at the End of a Disc
You don't have to record a whole disc at once. Until you finalize the disc, further recording is possible from the end of the last track you recorded (assuming there are fewer than 99 tracks already on the disc). Here's how to check what's on the last recorded section of the disc before recording new material:
1
1 2
Press ¶ RECORD.
The recorder goes into record-pause mode.
2
Press and hold 1 (fast-reverse).
You'll hear the last recorded track in reverse. Release the button and the track plays normally to the end.
� While the track is playing you can use the 1 and ¡ (fast-reverse/
forward) buttons
21
� If you press ¶ RECORD again while the track's playing, the recorder
jumps to the end of the track and goes into record-pause mode again. When the track has played out, the recorder automatically enters recordpause mode again.
3
Hi-bit Legato Link Conversion
Once the player is back in record-pause mode you can go ahead and record normally.
If you decide you don�t want to record, just press 7 (stop).
Recording Blank Sections
This feature is useful when you want to put some space at the end of a recording session so that the next recording doesn't start after the last too closely, but use it wherever you need some blank space recorded on the disc. There are a couple of restrictions on using record mute: you can only record one mute per track; and you can�t begin a recording with a muted section� you can use it only after the recording has started, or at the end of a recording.
1 2 2 1
1
While recording or during record-pause mode, press � REC MUTE.
A blank space of about four seconds is recorded, then the recorder goes into record-pause mode.
� If you press and hold � REC MUTE, you can record a blank for as long
as you hold down the button.
Additional Features
2
Press 7 (stop) to finish the recording session.
� To restart recording, press either 3 (play) or 8 (pause).
Hi-bit Legato Link Conversion
29
<PRB1286>
