SONY PFV-D300
Instrukcja Serwisowa

1-6. Installation of the Optional Board

4. Turn the board levers in the direction of the arrow 1 after inserting the board to the end of the slot by hand.

Rear side 1. Remove the two screws and remove the blank panel corresponding to the slot which the board has been installed in the front. n Keep the blank panel which is removed.

1

2 B 3x6

2 1 2 Board lever 1 Blank panel

1

2 Board lever

1 Insert 2 Remove

2. Insert the connector panel. 3. Secure the connector panel with the two screws securing the blank panel.

5. Stick the slot label supplied with the optional board onto the board lever. 6. Install the board retainers. 7. Install the front panel. n When removing the board, turn the board levers in the direction of the arrow 2, and pull out the board toward you.

B 3x6

Connector panel

n Do not open the slot for realizing an air-colled effect of this unit. Install the blank panel to an empty slot.

PFV-D300

1-5 (E)