Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 8 (kliknij aby zobaczyć)
Panel Descriptions
Main Unit: Front Panel
1 2 3 4 5 6 7 8 9 10 11 12
V-DRUMS/CH1 1. PUNCH Switch
Setting this switch to ON produces a dynamic drum sound while increasing the perceived power of the sound. Switch this on whenever needed. * The effect of this function is applied to the device connected to V-DRUMS/CH1.
6. VOLUME Knob
Adjusts the volume of the main unit. You can use this to achieve a volume balance between the main speaker and the satellite speakers. * This does not affect the sounds output from the SPEAKER OUT, headphones, and LINE OUT outputs. * No sound is output from the PM-30's speakers when the WOOFER CONTROL VOLUME knob is set to 0.
2. VOLUME Knob
Adjusts the volume of the device connected to V-DRUMS/CH1. * If you connect a sound module with a high output level , distortion may occur if you turn the volume level up too much. Be careful.
MASTER EQUALIZER
Adjusts the low-frequency tone quality. Adjusts the midrange tone quality.
CH2
3. VOLUME Knob
Adjusts the volume of the device connected to CH2.
7. EQUALIZER (BASS) Knob
8. EQUALIZER (MIDDLE) Knob 9. EQUALIZER (TREBLE) Knob
Adjusts the high-frequency tone quality.
CH3
4. VOLUME Knob
Adjusts the volume of the device connected to CH3.
10.VOLUME Knob
Adjusts the volume of the overall system. * When headphones are connected, this adjusts the headphone volume.
WOOFER CONTROL
5. MODE SELECT Switch
This switches the range of sound output from the main unit. SUBWOOFER: Only sounds in the low-frequency range are output. When used together with the satellite speakers, this mode produces a drum sound with great presence. This is optimal when VDrums stands are used. FULL RANGE: This provides powerful, full-range sound, from low frequencies on up to the high end.This also enables the unit to be used for smaller ensemble performances as a main speaker for the V-Drums. * This does not affect the sounds output from the SPEAKER OUT, headphones, and LINE OUT outputs. �Setup Examples� (p. 12)
11. PHONES Jack
* This does not affect the output to LINE OUT.
Connect the system headphones (optional) here. * No sounds are output from the main unit speaker or satellite speakers when headphones are connected.
12. POWER Switch
This turns the power to the system on and off. * If you need to turn off the power completely, first turn off the POWER switch, then unplug the power cord from the power outlet. Refer to �Power Supply� (p. 5). * To prevent damage to the system and any connected devices, turn the power on and off according to the instructions in �Switching the Power On and Off� (p. 10). * This unit is equipped with a protection circuit. A brief interval (a few seconds) after power up is required before the unit will operate normally.