Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 2 (kliknij aby zobaczyć)
Wall-Mounting the Speaker Using the Wall Brackets
The customer is responsible for proper selection and use of mounting hardware and for correctly and safely wall-mounting the speakers.
TOWER
Full Range
High Pass
TOGGLE SWITCH
WALL ANCHORS AND SCREWS NOT PROVIDED
CENTER
F ul l
VIEWING CUP IN BOTTOM OF SPEAKER TOWER
WALL BRACKET
STEP 3 � Tower Only: When using the tower as a surround
speaker, set Toggle Switch in tower cup to �Full Range.�When using as a front channel, set Toggle Switch in tower cup in bottom to the �Full Range� position. Please consult the Prelude MTS Subwoofer manual for exceptions to this setting.
STEP 1 � When mounting each bracket to the wall, try and
position it so that you anchor it to wall studs. Be sure to anchor the bracket firmly to the wall to sufficiently hold the speaker. Use screw positions as shown in Step1.
P a ss R an ge
REMOVE SHORT AND REPLACE WITH LONG 10-32 SOCKET HEAD SCREWS PROVIDED
WALL BRACKET FLANGES
FLANGE CUTOUTS
H ig h
RED =
+
10-32 SOCKET HEAD SCREWS
BLACK =
�
10-32 SOCKET HEAD SCREWS
BOTTOM END CAP
WALL BRACKET BRACKET COVER
NO STRIPE =
�
STRIPE =
+
SPEAKER CABLES CABLES
STEP 4 � Tower: Remove (2) existing screws in top and (4)
in bottom of Speaker Tower as shown. Feed your speaker cables through the slot in the Bottom End Cap as shown and connect to the terminals. Place the Bottom End Cap on the Speaker Tower bottom. Center: Attach speaker wire to terminals as described in the center-channel Owner�s Guide.
STEP 2 � Align Flange Cutouts in Bracket Cover flange with
Wall Bracket flanges and slide Bracket Cover onto Wall Bracket. Now slide Bracket Cover so that it centers on the Wall Bracket. This should be a tight fit.
