PIONEER PRO-141FD/KU/CBXC
Instrukcja Serwisowa

5

6

7

8

A

For Diagnosis

For PRO-141FD

Terminal panel ELT

1 2

Remove the two screws. (BPZ30P080FTB) (KRP-600M only) Remove the two hexagon headed screws. (ABA1382)

2

�2

Terminal panel MTR

For KRP-600M

2

�2

1

1
B

Support bracket MTR

3 4 5

Remove the four screws. (PMB30P060FNI) Temporarily tighten one of the screws that was removed in Step 3. Disconnect the flexible cable from the MAIN Assy.

4

3

3

5 3
MAIN Assy I/O Assy

C

3

6 7

Remove all the cables that are connected to the I/O Assy from their clamps. Remove the cables that are connected to the CN1201 connector from their clamps.

6

6 A 6
CN1201

7 7
D

Note: In a case where the ambient temperature is 35 °C or less You can reverse the I/O Assy in Step 8 without removing the cables from their clamps in Step 7 above, if you detach the CN1201 connector from the I/O Assy and remove the cables connected to the connector from Clamp A.

8

Detach the I/O Assy with support bracket MTR attached. Reverse the I/O Assy in the direction shown in the photo below:

9

Hook support bracket MTR onto the temporarily tightened screw then reconnect the flexible cable to the MAIN Assy.

9
E

8

I/O Assy

Support bracket MTR

I/O Assy

F

PRO-141FD
5 6 7 8

181