PRO-JECT PRO-JECT29WOOD
Instrukcja Obsługi

Mains power connection, switching on and off
The turntable is supplied with a captive mains lead (13) which allows connection to your country's mains supply. Check the label before plugging into the mains to ensure compliance with the mains rating in your house. Pressing the power switch (20) alternately starts or stops the motor.

Fitting the lid
Fit the lid (dust cover 10) carefully over the hinge prongs and adjust the screws (12) until the lid stays open where you want it to without being too stiff to open or close.

Maintenance and cleaning
Your record player requires little or no regular maintenance. Remove dust with a slightly moistened antistatic cloth. Never use a dry cloth because this will create static electricity which attract more dust! Antistatic cleaning fluids are available at specialist stores but must be applied sparingly to avoid damage to rubber parts. It is recommended to fit the needle cover before cleaning or maintenance is carried out to avoid damage. If the player is not used over a long period of time the drive belt can be removed to prevent unequal stretching. Always disconnect the record player from the mains power supply as a precaution before maintenance!

Useful tips
The lid is not only a dust cover but also a resonant structure likely to be excited by, and to pass into the plinth, the acoustic energy emanating from your loudspeakers during replay. It is therefore recommended that the lid be removed for optimum sound quality. The finger lift (21) may be fitted on top of the headshell under the cartridge fixing bolts or nuts - not between headshell and cartridge body - but may impair the sound quality by adding resonances. It is supplied to ease placement of the arm over the record and may be omitted. The use of the lift (7) considerably facilitates use of the arm without the finger lift. The record player should be positioned on a low-resonance surface such as wood or multiple layer ply board to avoid structural vibrations disturbing replay.

Technical data
Mains power supply Power consumption Nominal speeds * Speed variance Wow and flutter Signal to noise Downforce range Effective tonearm length Overhang Dimensions (H x W x D) Weight

PRO-JECT 2.9 Wood
220-240V, 50 cycles 2VA 33,33/45,11 r.p.m. > ± 0,5 % > ± 0,08 % > -70dB 10 - 35mN 9 " (230mm) 18mm 133 x 462 x 350mm 8,6kg

PRO-JECT 2.9 Classic
220-240V, 50 cycles 2VA 33,33/45,11 r.p.m. > ± 0,5 % > ± 0,08 % > -70dB 10 - 35mN 9 " (230mm) 18mm 133 x 462 x 350mm 8,2kg

*(pulley for 78 r.p.m. available extra)

6