PANASONIC PT50LCZ70
Instrukcja Obsługi

ASPECT Controls
Notes
� When input mode is CARD, the aspect is set to 4:3 and cannot be changed. � If the mode selected does not match the aspect ratio of the input signal, the original picture quality may be affected. � If using this Projection Display in places, such as cafes or hotels, with the aim of displaying programs for a commercial purpose or for public presentation, please note that by using the aspect ratio (16:9) selection function to change the aspect ratio, you may be infringing on the rights of the original copyright owner of that program under copyright protection laws. � If a 4:3 picture is projected in wide screen, distortion may occur around the edges so that part of the picture may no longer be visible. We recommend viewing in 4:3 mode so you can enjoy the picture as it was intended to be seen.

Mode

Picture

Explanation JUST mode will display a 4:3 picture at maximum size, but with aspect correction applied to the center of the screen so that elongation is only apparent at the left and right edges of the screen. The size of the picture will depend on the original signal.

16
JUST

JUST

9

Changing the Aspect Mode
Lets you choose the aspect mode based on the format of the received signal and your preference. Procedure
4:3

4

4:3 mode displays a 4:3
3

4:3

picture at the standard 4:3 size.

1. The aspect mode changes each time ASPECT is pressed.
16

JUST FULL

4:3 ZOOM ZOOM

ZOOM

9

ZOOM mode magnifies the central section of the picture.

� When an HD signal (1080p/1080i/720p) is received, the mode switches between FULL, H-FILL, JUST, and ZOOM. FULL ZOOM H-FILL JUST FULL
FULL

16 9

� During PC input, the mode switches between 4:3 and FULL only. 4:3 FULL
16
H-FILL

FULL mode displays the picture at maximum size, but with a slightly elongated appearance.

H-FILL mode enlarges a 4:3 image horizontally to the sides
9

H-FILL

of the screen. The side edges of the image are cut off.

33

Basic Operation