|
Kto jest w sklepie?
Sklep przegląda 6043 gości
|
Kategorie
|
Informacje
|
Polecamy
|
|
|
|
|
Dla tego produktu nie napisano jeszcze recenzji!
;
Wszystko w porządku.
Instrukcja czytelna i kompletna.
Dziękuję.
all right!
thank you.
;
Bardzo dobra instrukcja. Zawiera wszystko co potrzeba, polecam!
;
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
;
Instrukcja bardzo czytelna. zawiera co potrzeba. Polecam
;
...instrukcja serwisowa w pełni czytelna i kompletna. Dziękuję!
Disassembly for Service
Note:
Board ground wires may have to be disconnected to disassemble some boards. All ground wires must be reconnected using jumper leads, if necessary, before power is applied to PTV for service. 2. Remove (3) screws from around the A/V terminal board (marked with arrows).
Speaker Grille Removal
(Figure 8.) 1. The 2 Speaker Grilles are secured to the wooden base of PTV. Grip each panel from the sides and botton part, gently pull forward to remove. When reassembling, make certain to firmly press on the panel where the insertion points (4) are located, one on each corner. 2. The Center Front Cover is secured by 4 screws.
Panasonic
Front Cover
Figure 9. Lower Cabinet Back Removal
Cabinet Back Cover Removal
(Figure 10) 1. First remove the Cabinet Back Lower Cover. 2. The top back cover is secured with (16) screws around its perimeter (See Figure 10 for screws location). 3. Be careful not to damage the mirror attached to the underside of cover.
Speaker Grill
Figure 8. Speaker Grill Removal.
Keyboard Removal (7-Key Button)
(Figure 8) 1. Remove the Speaker Grill. (see Figure 8) 2. Unplug the cables (2) from the Keyboard assembly. Remove the 2 screws from the left and right sides of Keyboard assembly. Tilt the Keyboard assembly upward and release it from the screen frame assembly.
Speakers Replacement
1. Remove the speakers grill. (see Figure 8) 2. Each speaker set is secured to the cabinet with (4) screws. 3. Disconnect the R & L speaker lead connectors from the speaker units.
Cabinet Back Lower Removal
(Figure 9) 1. Remove (7) hex screws around its perimeter marked with arrows. (See Figure 9 for screw location).
Figure 10. Cabinet Back Cover Removal
- 11 -
Service Manual
|
|
|
> |
|