jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
Tekstowy podgląd strony 62 (kliknij aby zobaczyć)
4. 1) Then, press and hold the VOLUME DOWN button on the unit and the MOVE key on the remote for more than 5 seconds. The unit will go into the Factory Adjust Mode. (FACTORY ADJUST menu will appear.)
FACTORY M: V S F O P 0 I O A T A 3 D U N H R ADJUST 1/1
a. Mechanical Picture Position Adjustment
1) Loosen the 4 Screws on the Projection Unit.
Projection Lens Screw Screw
0780 S:0307010 EO ADJ ND ER TIAL
Screw
Twist
Twist
Screw
DEFAULT SET (SELF CHECK)
<Factory Adjust mode>
Fig. 4-4 2) Then, press the CH UP/DOWN key on the remote to select �OTHER� on menu and press the ACTION key. (OTHER menu will appear.)
OTHER 1/1 RGB1
<Front View>
Fig. 4-6 2) Adjust the Projection Lens by twisting so that the long line �g� and the long line �h� are within 4 dots. (The long line �g� and the long line �h� will be almost aligned horizontally.)
O O F G
P P P C
TH TV :00 :03
P P 0 0
O O 0 6
S S 0 3
I I 0 0
07 00 PROTEC
OPT OPT
HPOSI VPOSI
16 FE
<Factory Adjust Mode> (OTHER menu 1/1)
Fig. 4-5 5. Press the VOLUME UP/DOWN key on the remote. (Focus screen will appear.)
"G" long line "g" <Focus Screen> long line "h" "H"
OPT OPT
HPOSI VPOSI
16 FE
"G"
within 4 dots
"H"
<Focus Screen>
Note: If the Projection Lens is twisted left, the Focus Screen twists left. If the Projection Lens is twisted right, the Focus Screen twists right. 3) Tighten the 4 Screws while fixing the Projection Lens.
To release this mode: 1. After completing the ADJUSTMENT, press the CH UP/ DOWN key on the remote to return to the OTHER menu. 2. Then, press RECALL key twice to return to Work Mode, and press and hold the VOLUME DOWN button on the unit and the RECALL key on the remote for more than 5 seconds. Alternatively, turn off the power. 3. Then, install the Optical Cover with the 2 Screws and the Front Cover Unit.
