Adjusting the picture to the desired setting (continued)
Adjusting the white balance (High / Low)
Adjustment procedure (Project a signal to be adjusted)
MENU AUTO SETUP LENS PICTURE POSITION OPTION SIGNAL LIST TEST PATTERN
Press the MENU button. ... The MENU screen will be displayed. Press the UP ( ) and DOWN ( ) arrow buttons to select PICTURE.
SELECT : ADJUST : ENTER EXIT : MENU
PICTURE COLOR TEMP BRIGHT CONTRAST COLOR TINT SHARPNESS H SHARPNESS V NR GAMMA MODE :� � �� : nnn : nnn : nnn : nnn : nnn : nnn : ��� �� : 2.2
Press the ENTER button. ... The PICTURE screen will be displayed. Press the UP ( ) and DOWN ( ) arrow buttons to select COLOR TEMP. ) arrow buttons to select the desired setting
Press the LEFT ( ) and RIGHT ( from those indicated below.
Use the control level buttons ( + and � ) to adjust the setting level. Adjustment Item R (Red) G (Green) B (Blue) Operation Press the [+] button. Press the [�] button. Press the [+] button. Press the [�] button. Press the [+] button. Press the [�] button. Adjustment Details The red component becomes stronger. The red component becomes weaker. The green component becomes stronger. The green component becomes weaker. The blue component becomes stronger. The blue component becomes weaker. Max. value 255 Min. value 0�� Adjustment Range
NOTE
� If these adjustments are not made correctly, none of the colors will be reproduced correctly. � If you make an error in adjustment so that the colors do not match correctly, press the STD button while one of the individual adjustment screens is being displayed. Only the item being displayed will be reset to the factory pre-settings. � The projection of a built-in test pattern (Refer to page 65.) does not allow the white balance adjustment. Be sure to project an external input signal for this adjustment.
