If loading does not start after DC Power Supply is applied, DO NOT continue applying DC Power Supply.
5.1.7.1. Remove a jammed tape as follows:
1. Remove a Screw and remove the EVR Cover.
Fig. 4-1
2. Place the unit with the Cassette Cover facing upward. 3. Connect the TP Board Kit through the TP Board slot. 4. Apply +3VDC Power Supply to TP20 (+) and TP21 (-) on the TP Board to unload the mechanism. It normally takes approx. 6 seconds to unload the Mechanism to EJECT position. Then, remove the Power Supply and remove the TP Board Kit.
Fig. 4-2
